Coordinate welding machine
The head on a column moves along X, Y and Z, and a rotator on the table turns the pipe
Drag to rotate the model; scroll or pinch to zoom.
What it is
A welding table on top of the machine cabinet. At the back of the table is the X axis on linear motors, on it the Y carriage, and on the carriage the Z column with the laser head. There is no gantry: the column stands on the carriages, so the table is open from the front and from above. The head moves along three linear axes: X along the table, Y towards the operator, Z up and down. The head has beam wobble, turns around the vertical and changes its tilt. Inclined, it goes around branches and nozzles; vertical, it makes flat welds. On the DY-FLW2000 the tilt is changed with the sixth axis on the hand-wheel pendant.
A slide rail runs along the table. On the left is a rotator with a jaw chuck, on the right a tailstock moves along the rail, with detachable supports between them. This holds a round or square pipe of any length that fits the table. A flat part is placed directly on the table.
The X axis base, which lies at the back of the table, can be lifted by hand and set on the front edge of the table. The head then travels beyond the table, and tall parts stand upright on the floor in front of the machine, like the heat exchangers in case K-0003.
Which welds it makes
- Circular butt joints of pipes: the head stays over the joint and the rotator makes one turn.
- Branches and nozzles on a pipe, tee joints: the head turns around the branch, as on the weld photo in the Dayue description.
- Contour welds in the plane of the part: circles, lines, arcs on a sheet or a lid.
- Circular welds around the tubes of a heat exchanger tube sheet.
Tall bosses and nozzles on a large part, where the head has to go around them at 45° over a long stroke, are easier on a gantry-circular machine.
On the 3D model
The machine follows the Dayue DY-FLW2000 layout: a 2000 mm table, the rotator on the left, the tailstock on the rail on the right, displays and chiller at the sides, a hand-wheel pendant on the cabinet. The tilted head goes around five branches on the pipe in turn, turning around the vertical. Before the joint between the pipe and a coupling, the operator turns the wheel on axis 6: the head tilts back and forth and stands vertical, and the vertical head welds the circumferential seam while the rotator makes one turn. Then the pipe is removed, the rotator, tailstock and rail are taken off, and only on the clean table is the X axis base moved to the front edge. The head stays vertical and welds the tubes in the tube sheets of three heat exchangers standing on the floor in front of the machine; the tubes are flush with the sheet. Then the base goes back, the rotator and pipe return, and the wheel tilts the head again.
Options
- Rotator (A axis): a chuck with a tailstock for pipes. Built into the DY-FLW2000.
- Computer vision: the CCD camera shows the weld close up and helps to aim the head.
Models
- Dayue DY-FLW2000: 2 kW laser with beam wobble, 2000 mm table, strokes 1500 × 300 × 500 mm, rotator and tailstock.
- Dayue DY-FLW1500: 1.5 kW laser with beam wobble, strokes 500 × 400 × 300 mm.
Cases
- K-0003. Tubes to the tube sheet of a heat exchanger: dozens of circular welds in one plane.